|
Who's Online
There currently are 5798 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
A good manual! fast service and good qualityi for pdf document.
thanks!
;
Very helpful and complete manual. Maybe only one negative is schematics have sometimes unreadable name of the parts. But it's not a big problem.
;
Excellent high quality schematics brought my old Heidelberg back to life. Fast download at a reasonable price. Thanks.
;
This document is just what I was looking for, it´s very useful, it contains adjustment procedures for the final stage of the power amp and also
has a complete wiring diagram and description of the main semiconductors used in the design.
;
Dear Sirs,
Thank you for the fast support, the manual does provide all necessary information to repair the radio. All schematics are in a good quality for reading.
The manual fits 100% to my requirements as a technican.
Kind regards Thomas
5. Buzzer check TEL key : Key input sound every 1 second Business card key : Sound alarm 1 MEMO key : Sound alarm 2
BUZZER
1 BEEP 2 ALARM 1 3 ALARM 2
EXECUTING !
Sound can be stopped by pressing the any key. While an alarm is sounding the screen display is as shown at left. If an irregularity is found in voltage of battery while the alarm is sounding, the alarm will stop. After 256 seconds, the alarm will stop automatically.
6. SB-60/SB-62 cable interface check The TEL to SCHEDULE keys are used to select mode; the CALENDAR, HOME TIME and WORLD TIME key are used to set the transmission paraments. The three charactors that appear on the right side at display represent the parameter. In the case of the exampledisplay, it indicates 7 BIT, NON PARITY, 9600 BPS. The operation continues until stopped by pressing the ESC key and then pressing the ON key for all modes. DISP CHNG key : Return to menu mode TEL key : Transmission mode. The data of transmission is "H"and it is sent out by the data of &H34 and &H38 by the Xon/Xoff control. Business card key : Reception mode. Make sure to set the parameter to match that of the transitting side. The data received appears on the display. MEMO key : Loop back test. Short the Tx and Rx terminals for this test. Transmit and check from &H20 to &H7E. When complete, the message 'CHECK COMPLETE' is displayed. SCHEDULE key : output the following ASCII code by Xon/ Xoff control. !"#*+,-/0123456789: ABCDEFGHIJKLMNOPQRSTUVWXYZ abcdefghijklmnopqrstuvwxyz A line end code is added with each line.
I/F
1 TRANSMIT 2 RECEIVE 3 LOOP 4 ASCII 7N9
Parameter
EXECUTING !
CALENDAR key : Switch the data length 7 bit(7) or 8 bit(8) HOME TIME key : Switch the parity bit : NON(N)�EVEN(E) �NON(N) �ODD(O) WORLD TIME key : Switch the transmission speed : 9600(9)�4800(4)�2400(2)�1200(1) To communicate two machines, please set the transmission machine before setting the receiving unit. To release communication, press ESC button. In this case, the break code is sent to receive units. Therefore, both machines display "TRNS BREAK !" and communication will be stopped. Also, if the error is occurred, both machines display "TRNS ERROR !" and communication will be sttoped.
� 27 �
$4.99 SF8350 CASIO Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|