I used your service and I found myself well I need service manual teac v plate 770 and I was able to access and remove the belt that erno routes. thanks I recommend it to all
At first I thought there had been a mix up as I required the service manual for the cassette unit and the one supplied was for the CD unit. However when I scrolled further down I realised that both had been scanned together! This enabled me to dismantle and repair the cassette unit as intended and I also have a copy of the manual for both the CD and graphic equaliser units should I ever need them. Thanks very much for a great service.
Text excerpt from page 7 (click to view)
D
C G
A
I
H
GND B E
F
A Power ON 9.65 VAC
Plug out 0
B 10.52V
0
C 5.76V
0
D 10.45V
0
E 0.78V
0
F 0.12V
4.13V
G Pulse
0
H 5.07V
4.30V
I -23.9V
0
Voltage level is measured at the following condition. 1. Plug the power cord in AC outlet. 2. Mode switch position : REG, display 0.00 3. Put in the memory protection batteries. 4. Plug out : Plug out the power cord , the memory protection batteries in.
6-2. Reset circuit
VDD
S-80728AN
GND
When the voltage level at the pin no.17 of CPU is not stable, CPU does not work properly. To make a stable voltage, the reset IC(S-80728AN) is used for this circuit. In case the voltage level of VDD becomes down output terminof reset IC is out the stable voltage.