There are currently no product reviews.
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
It is OK, this manual help me to repair my dynacord
Good manual. Even it is an old printed manual, it is well scanned and complete, with all drawings, schematics and parts list. Very good return for the cost.
I'm very satisfied with my purchase. It resolved my problem. Owner-manuals.com is a very very good place.
Veramente completo, dettagliato e perfetto nella visione. Perfect, thanks!
7-4. Printer Pin Arrangement Diagram
Connection RD terminal Pin No. 1 Pin No. 15 Connection Character selective magnet column No.1 13
Character selective 3 magnet column No.1 2 4
Ribbon shift magnet Electromagnet (+)
Notes: 1. Column numbers match the physical arrangement of the columns on the print wheels. 2. Column numbers are assigned from 1 to 18 from the frame motor side. 3. Pin numbers are assigned from 1 to 27 from the frame motor side. 4. The spark arrestor diode is connected as shown below.
Motor power supply (+) Detector power supply (+) Timing signal Detector power supply (â)
(Example of compatible diode: 1S2075K or equivalent)
Motor power supply (â)
Motor power ON/OFF
*2 8.0ms min.
T10 T11 T12
0.7ms max. 8 0.7ms max. 0.7ms max.
Character selective magnet No.n Ribbon shift magnet
(Print operation) (Normal paper feeding operation)
Notes: 1. The signals in must be prepared by the user. 2. The pulse is indicated by a dot-dash line (*1) is generated for continuous printing. The next print cycle can start immediately after the leading edge of the timing signal Ts. 3. As shown by a dashed line (*2), the timing signal may go low at motor power-on or upon reception of a Print command. â9â