I am so happy found this site as it consists of so many Manuls and easy to aquire. This onei s exactly what I wanted and much more as it has info on not only how to use the tuner but how to repair it as well. I will come here 1st before purchasing else where! Thanks owner-manual.com!
Notes: 1. Column numbers match the physical arrangement of the columns on the print wheels. 2. Column numbers are assigned from 1 to 18 from the frame motor side. 3. Pin numbers are assigned from 1 to 27 from the frame motor side. 4. The spark arrestor diode is connected as shown below.
Motor power supply (+) Detector power supply (+) Timing signal Detector power supply (â)
(Example of compatible diode: 1S2075K or equivalent)
Motor power supply (â)
Motor power ON/OFF
*2 8.0ms min.
T10 T11 T12
0.7ms max. 8 0.7ms max. 0.7ms max.
Character selective magnet No.n Ribbon shift magnet
(Print operation) (Normal paper feeding operation)
Notes: 1. The signals in must be prepared by the user. 2. The pulse is indicated by a dot-dash line (*1) is generated for continuous printing. The next print cycle can start immediately after the leading edge of the timing signal Ts. 3. As shown by a dashed line (*2), the timing signal may go low at motor power-on or upon reception of a Print command. â9â